Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-19-2001, 09:54 AM
|
#1 |
|
Registered Member
Join Date: Oct 1998
Location: Dayton, OH USA
Posts: 678
|
If the '92s are the same as what was on my '89 (and I think they are), basically they just pull off. There are a couple of metal tabs that dig into the plastic to hold them on, along with a sticky weatherproofing that they seal on. Be carefull and pull them out evenly or they will bind and break.
Hope this answers your question. ------------------ See my 1985 Mustang GT |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Export tail lights? | Moxie | Appearance & Detailing | 2 | 03-02-2004 08:51 AM |
| Clear tail marker lights | 5P0INT0 | Windsor Power | 7 | 09-10-2003 06:53 PM |
| Need '83-'86 Tail Lights...Again | RMARIANI | Windsor Power | 1 | 04-13-2002 09:41 PM |
| Tail lights working on and off... | Badboy2777 | Small Ponies | 1 | 04-11-2002 12:08 AM |
| What wire gauge is used for tail lights? | Nitrous Al | Windsor Power | 4 | 11-15-2001 08:49 PM |