Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-18-2001, 03:23 AM
|
#3 |
|
Registered Member
Join Date: Apr 1999
Location: Overland Park, KS, USA
Posts: 1,631
|
I've heard of some cars having wiring harnesses that are too tight...hence the stalling while the steering is locked. The turning force can jar the engine slightly and tug on a wiring harness....causing the car to stall. As for reversing up a steep driveway...I think Rustang is right. Sounds like your idle is a bit too low. I doubt it's the fuel pump. If anything with your car's @ss end higher than the engine the fuel should get gravity to assist it in it's trip to the engine. Sounds like a sensor problem to me. Run a diagnostic and see what codes you can pull.
------------------ 1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stalling caused by clutch? | RoushRacing6N17 | Windsor Power | 5 | 03-01-2004 08:18 AM |
| Stalling Problem | RoushRacing6N17 | Windsor Power | 0 | 01-16-2004 08:36 PM |
| My '02 GT is stalling & bucking, suggestions? | BryantD | Modular Madness | 1 | 12-20-2002 03:02 AM |
| To all who asked me to check the codes for stalling problem, read please. | HAITHAM | Windsor Power | 2 | 09-29-2001 07:09 AM |
| Stalling fixed, but now won't start when cold !! | jetuomi | Windsor Power | 6 | 09-27-2001 02:42 PM |