Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-13-2001, 07:39 PM
|
#2 |
|
Registered Member
Join Date: Nov 2001
Location: Sunny, Hot, Sebring, Florida
Posts: 725
|
Well, with the 86 your dealing with flat top pistons, no flames, but how do you know that piston to valve clearance is okay with ANY rockers without checking? Or have you?
1.7's will give you .30 thousands more lift, even if clearance is okay, you should definetly replace the valve springs. Let alone the Speed density issue now.
__________________
Remember...2nd place is 1st place for losers! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| Head swap question | Badass_yellowGT | Modular Madness | 11 | 11-04-2002 11:19 PM |
| head bolt question... | avbcon12 | Windsor Power | 4 | 02-23-2002 09:13 AM |
| Head Question | DiabloLX | Windsor Power | 1 | 11-06-2001 05:26 PM |
| stock Head question | Patrick Boetticher | Windsor Power | 2 | 06-11-2001 05:02 PM |