

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#6 |
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
![]() Tim, I'm not sure about the clearance but you should definately change the springs when you do it, Jegs has a set of crane springs for about $60, i got my comp's from summit for about $70
when you helped me put my rockers on i didnt notice much gain at all, and after i swapped in the T-5 i noticed i had valve float at about 5400 and higher, when i put the new springs in i could definately notice a good gain in power, not to mention i could rev all the way to the limiter ![]() i dont know how much the springs helped, but with the combination of them, an elec. fan, and VERY cool weather i picked up over 5mph in the quarter (101.4 to 106.8best) are you gonna be doing it soon? i've got a break from school starting thursday and going all the way through next week so i may stop by some time and see how its goin good luck , talk to you later, Drew
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
Head swap question | Badass_yellowGT | Modular Madness | 11 | 11-04-2002 11:19 PM |
head bolt question... | avbcon12 | Windsor Power | 4 | 02-23-2002 09:13 AM |
Head Question | DiabloLX | Windsor Power | 1 | 11-06-2001 05:26 PM |
stock Head question | Patrick Boetticher | Windsor Power | 2 | 06-11-2001 05:02 PM |