Covering Holes in the Engine bay?

Rick 91GT · 03-19-2001, 08:55 AM

Sorry no pic's yet, I am still mocking up the templates. I basically just followed the contour on the inner fender but I did have to angle out to cover the mess of wires where the solonoid was, I wasn't going to drill holes and remount those to the fender, way too much work. I have seen a lot of guys make plates to cover those areas, in a old MM&FF a guy in a orange stang had the plate on ahinge and his MSD was hidden in the fender well. I'll e-mail you a pic of my Dads 93 Cobra he made a cover to go over his Pro-M 83mm and filter combo, that is exactly what I am doing on the passenger side.

------------------
My Ride<A HREF="http://members.mustangworks.com/rick91gt/index.html" TARGET=_blank> Check Out My
Site</A> 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to
a 1262, Anderson N-61, 24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radi

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rare Mustangs....Got One?	1969Mach1	Blue Oval Lounge	22	09-25-2010 04:59 AM
Very bad experience with Engine Dynamics of San Jose CA	JAGraff	Small Ponies	0	05-12-1999 02:27 AM
Very bad experience with Engine Dynamics of San Jose CA	JAGraff	Racer's Club House	0	05-12-1999 02:27 AM

03-19-2001, 08:55 AM	#6
Rick 91GT Procharged! Join Date: May 1999 Location: Hanover, PA Posts: 1,539	Sorry no pic's yet, I am still mocking up the templates. I basically just followed the contour on the inner fender but I did have to angle out to cover the mess of wires where the solonoid was, I wasn't going to drill holes and remount those to the fender, way too much work. I have seen a lot of guys make plates to cover those areas, in a old MM&FF a guy in a orange stang had the plate on ahinge and his MSD was hidden in the fender well. I'll e-mail you a pic of my Dads 93 Cobra he made a cover to go over his Pro-M 83mm and filter combo, that is exactly what I am doing on the passenger side. ------------------ My Ride<A HREF="http://members.mustangworks.com/rick91gt/index.html" TARGET=_blank> Check Out My Site</A> 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262, Anderson N-61, 24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radi