Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-19-2001, 11:59 PM
|
#5 |
|
Registered Member
Join Date: Sep 1999
Location: boise,idaho
Posts: 220
|
I'm sorry I didn't make myself clear since you have a late model roller block by all means stay with a roller cam, but instead of running a hydrualic setup go with a Mechanical/Solid roller setup. They do require higher seat pressure springs so specify that when ordering the heads. They simply out perform the other set-ups. My two cents.. Mac
__________________
393,9.5" 351W,830 Holley,Victor Jr,Home made Cool Air Pan, Pro Billet MSD, MSD 6AL, XE 284H Xtr-Com cam, 240-246 @.050, 540-544, M/T Et streets, Mac Upper and Lower, Control Arms, 3:73 US Gear,Mini Spool, Eagle Long rods, Mac Windage tray, KB Pistons, Scat crank, 4000 rpm stall convertor, C-4 trans, Airflow Research 185cc, Hooker long tubes 3", exhaust, S&W 6 point roll cage, 11.2 at 121 mph. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EFI 351W How fast should it go? | 89fast5oh | Windsor Power | 9 | 11-25-2003 03:28 PM |
| 351W Heads on a 87 302 Block | NitroNixon | Windsor Power | 5 | 05-08-2003 09:29 PM |
| 351W heads on 289 stock engine | sleeperstang | Classic Mustangs | 5 | 11-21-2002 08:35 PM |
| Going to the Track for my 1st time . . .Any hints? | Mac_5.0 | Windsor Power | 9 | 08-01-2002 08:51 PM |
| HP #'s from a built 351W versus FMS 351 versus stroker | stroker393 | Windsor Power | 0 | 03-09-2001 10:24 AM |