Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-20-2001, 09:51 AM
|
#5 |
|
Registered Member
Join Date: Jun 1999
Location: Walker, MI, USA
Posts: 1,202
|
ok I wieght it in at 24LBS. I dont have a stock hood to wieght but It is around 60-70lbs I would say so likr 30-45lbs less for mine. OO a PIN ON one
__________________
Engine: steel mounts, Under drive pulleys, K&N, GT-40 Intake ported Lower, No power steering, No A/C, Mac cold intake, 65MM TB, 255 Fuel pump, 24's, AFR 165 58cc, Rocker Arms 1.7with the stock Cam, 1 5/8 short headers, offRoad X-pipe Drive Train: 3.55, T-5 with a Pro 5.0 shifter 12.656@107.71MPH See It at www.T-racing.com/mustang.htm |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stock Clutch Cable-vs Aftermarket | Scrapla | Windsor Power | 6 | 09-08-2004 08:00 PM |
| adding aftermarket sub to stock soundsystem | mineralgray02GT | Audio, Security, & Electronics | 2 | 08-03-2003 02:20 AM |
| Will my stock or aftermarket h-pipe bolt up to a 4 valve? | Redstang96 | Modular Madness | 0 | 08-29-2002 09:56 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |
| Aftermarket 4.6 Heads & Manifolds & Blocks...WHERE ARE THEY!! got any ideas? | Shawn | Modular Madness | 3 | 09-26-2000 02:07 PM |