Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-09-2001, 04:50 PM
|
#4 |
|
Registered Member
Join Date: Dec 1998
Location: MEMPHIS,TN.
Posts: 36
|
How much NOS will you be spraying??
Seems to me you would set your initial to about 8* that way if you're spraying 150shot you can just turn your dial to 8*. What is it...retard 1 or 2 degrees for 150 shot?? Not sure tho.JMO! Good Luck!! ------------------ FMS 373,Mac U/D Pullies,B&M shift kit,B&M Trans cooler, KYB's,FMS 65mm T/B,Moroso cold air kit,75mm Bullet,BBK sub frame connectors,Power-slotted rotors w/performance friction pads PST performance sway-bar kit,3G alternator,Maximum Motorsports Strut tower brace,Maximum Motorsports G-Load brace Maximum Motorsports lower control arms,Autometer,oil,H2O, volt MSD6AL,MSD Blaster coil,'Tiny Avenger'intake pipe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
| Timing Question | Comatose | Windsor Power | 2 | 03-22-2004 09:34 AM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
| timing chain or timing gear | mustang66teen | Classic Mustangs | 11 | 06-18-2001 08:44 PM |