5.0 Badge Removal

Phantom5oh · 03-20-2001, 02:01 PM

the ford badge on the trunk has three holes under it they aren't very big but they will need to be filled or they will rust... the 5.0 badges are easy to remove... just peel them off being carefull of the paint under them... they may leave some double sided tape but that easy to take off... either use a hairdryer to heat them up and rub it off or use oil, because tape/stickers have an oil based adhesive and oil will disolve it and they will again rub right off... hope this helps... i did mine, pretty easy

Phantom

------------------
1983 GLX Convertible 5-Speed, knife-edged crank, internally balanced, TRW 11:1, custom cam, ported Windsor Jrs, Manley Valves, CCs roller lifters, dual springs, ARP stud kit, 600cfm Edelbrock Torker 2, Mallory Ignition, Canton 7qt traps windage tray baffles, Hooker Super Comp Headers 1 5/8 primaries 3" collectors, Flowmasters, K&N, ASP puleys, Maximum Motorsports C/Cs strut tower K member brace, through floor subframes, Grant wheel, billet pedals, 93 seats, Keystone rims

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
5.8 cobra upper badge?	blk88lx	Windsor Power	1	03-18-2004 08:35 AM
Windshield Molding Clip Removal	Kisner	Classic Mustangs	7	04-30-2003 04:10 PM
Badge change - 5.0 to 5.4?	302 LX Eric	Blue Oval Lounge	11	02-05-2003 01:14 PM
badge removal	ny mustang gt	Modular Madness	2	09-19-2001 07:14 PM
347 badge	Smokedawg	Blue Oval Lounge	5	03-21-2001 12:46 AM

03-20-2001, 02:01 PM	#2
Phantom5oh Registered Member Join Date: Mar 2000 Location: Boston, MA Posts: 334	the ford badge on the trunk has three holes under it they aren't very big but they will need to be filled or they will rust... the 5.0 badges are easy to remove... just peel them off being carefull of the paint under them... they may leave some double sided tape but that easy to take off... either use a hairdryer to heat them up and rub it off or use oil, because tape/stickers have an oil based adhesive and oil will disolve it and they will again rub right off... hope this helps... i did mine, pretty easy Phantom ------------------ 1983 GLX Convertible 5-Speed, knife-edged crank, internally balanced, TRW 11:1, custom cam, ported Windsor Jrs, Manley Valves, CCs roller lifters, dual springs, ARP stud kit, 600cfm Edelbrock Torker 2, Mallory Ignition, Canton 7qt traps windage tray baffles, Hooker Super Comp Headers 1 5/8 primaries 3" collectors, Flowmasters, K&N, ASP puleys, Maximum Motorsports C/Cs strut tower K member brace, through floor subframes, Grant wheel, billet pedals, 93 seats, Keystone rims