Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-20-2001, 04:08 PM
|
#5 |
|
It's never clean enough!
Join Date: Jan 1999
Location: Shaler, PA
Posts: 1,542
|
The 5.0 badges on the sides are very easy to remove. All I had to do was get a hair dryer at medium to low heat and let it blow over the badge for about 5 or 6 min. After that, I got a piece of dental floss and, starting at the top of the badge, threaded it next to the paint. You just have to go slow and not pull too hard with the dental floss.
There was a little tape or adhesive left but it came off easily. ------------------ 91 GT AOD: 3.73's, Pulleys,PI Converter, 14.71@91.78mph (before pulleys) |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5.8 cobra upper badge? | blk88lx | Windsor Power | 1 | 03-18-2004 08:35 AM |
| Windshield Molding Clip Removal | Kisner | Classic Mustangs | 7 | 04-30-2003 04:10 PM |
| Badge change - 5.0 to 5.4? | 302 LX Eric | Blue Oval Lounge | 11 | 02-05-2003 01:14 PM |
| badge removal | ny mustang gt | Modular Madness | 2 | 09-19-2001 07:14 PM |
| 347 badge | Smokedawg | Blue Oval Lounge | 5 | 03-21-2001 12:46 AM |