Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-26-2001, 11:29 PM
|
#4 |
|
Registered Member
Join Date: Mar 1999
Location: Arcadia, CA, USA
Posts: 731
|
I also have a set of Edelbrocks that I wanted gasket matched...the machinist laughed at me. Apparently, Edelbrock heads are already matched pretty well to the gaskets. The Felpro 1250 intake gasket and 1415 exhaust fit pretty well.
If you're talking about porting and bowl work, then yes, it will help as long as you have the right combination of parts. You will probably lose some port velocity which will kill power down low, but your gears are good so hopefully you can get into the power band sooner. Yeah, I'd get them cleaned up but maybe not go overboard. That's just me though.
__________________
Russ L '91 LX - 331 w/ Procharger '03 Cobra Convertible - Pullied '94 Lightning '65 Mustang Coupe Last edited by NO SLO PK; 11-26-2001 at 11:38 PM.. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock heads | Scrapla | Windsor Power | 4 | 03-28-2004 08:39 AM |
| Edelbrock Victor racing heads #7721 | SmokinStangGT | Windsor Power | 4 | 05-09-2003 07:20 AM |
| edelbrock performer rpm heads | hippi97 | Windsor Power | 2 | 04-01-2001 08:40 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |
| Edelbrock heads and compression | flagg | Windsor Power | 10 | 02-10-2001 11:14 AM |