Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-26-2001, 06:25 PM
|
#1 |
|
Registered Member
Join Date: Feb 2000
Posts: 469
|
Changing clutch for the first time...
Well, I am going on leave tues to go to san diego and replace my clutch.
Any tips on how to make things go smoother? Any first time mistakes that I can avoid? never done a clutch before so ANY help is appreciated! ed ------------------ My Mustang 91 LX Conv. 52,000 orig mi. Hurst shifter, 3.55 grs, NOS 150 dry kit, MSD 6al, MSD timing control, malory coil, pullies, fms adj fuel reg, BBK 70mm tb, Pro-m 75mm maf, battery in trunk, JBA shorties, JBA subs, JBA strut tower brc, dynomax "super turbo" 2 1/2 exhaust, FMS billit distrib, Hotchkis lower cntrl arms, MAC Fenderwell cold air kit, off road h pipe. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stalling caused by clutch? | RoushRacing6N17 | Windsor Power | 5 | 03-01-2004 08:18 AM |
| Changing clutch | Just me | Windsor Power | 10 | 10-10-2003 01:45 PM |
| My report from racing at the NMRA event in Bowling Green (was ATTN: Lt. Dan) | andy669 | Racer's Club House | 12 | 10-08-2003 02:41 PM |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| Putting in new clutch. Anything left out? | 7000rpmisheaven | Windsor Power | 5 | 12-23-2001 02:34 PM |