Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-23-2001, 06:16 PM
|
#1 |
|
Registered Member
Join Date: May 1999
Location: Indiana
Posts: 512
|
White Face Gauge Install Questions
I have the MAC white face gauge kit and am in the middle of doing the install but can't seem to get the speedo needle off... All the others came off fine but the speedo one does not want to budge. Am I missing something? I have pried on it pretty hard and am afraid of breaking it but it is the last thing I need to take off to finsih the job. Any suggestions welcome...
------------------ 92GT all the free stuff and a few bolt-ons, lowered with Ebiach's and Koni's, Kenny Brown subframe connectors, lower G-brace and jacking rails. BBK upper and lower control arms, polyurethane bushings all around and Ken Bell blower, ram-air, 80mm mass air, etc. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| White face gauge question. Not which one to get either | Silver GT 01 | Modular Madness | 6 | 03-27-2002 08:11 AM |
| Fuel Gauge install questions | Chipdog | Windsor Power | 0 | 08-12-2001 07:06 PM |
| Previous owner F'd up white face guage install | withamc | Windsor Power | 5 | 05-24-2001 12:08 PM |
| White Face Gauge install tips | DemonGT | Windsor Power | 3 | 04-11-2001 12:25 AM |
| MAC white face gauge install - I screwed up | 2FastLX | Windsor Power | 2 | 03-26-2001 12:12 PM |