Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-18-2002, 04:53 AM
|
#1 |
|
Registered Member
Join Date: Oct 2000
Location: Ontario canada
Posts: 446
|
pinion bearing
My Mom's awd areostar blew the pinion bearing and seal lastnight
its a 8.8 rear with 3.73's but I've never had to reaplace or repair anything from the pinion part of a rear end when i changed my gear's everything stayed in and was in fine shape. I have two problems first I'm not sure what caused it to go. second I'm not sure what type of damage to expect when i open it up tommorrow. besides the bearing cup spacers bearings themselves and the seal of course what should i expect to replace . can this be fixed normally with the pinion still in the diff ? I'm thinking remove the drive shaft and diff pinion put the diff back in dive it ti the garage as a front wheel drive. any suggestions ? any idea on the labour for this ?
__________________
89 with 331 t3'/t4 hybrids. upr Suspention worked out finnaly . 9.89 144 mph . |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Throwout Bearing Blues | Rstng93 | Blue Oval Lounge | 2 | 06-19-2004 07:41 PM |
| clutch and throwout bearing questions | bmxmon | Classic Mustangs | 0 | 05-23-2004 04:32 PM |
| Pilot Bearing | Cody2552 | Windsor Power | 2 | 04-09-2003 09:30 AM |
| Pilot bearing replacement | Rebel79 | Windsor Power | 8 | 05-31-2002 02:12 PM |
| Ring and Pinion 373's | roadrunner93 | Windsor Power | 5 | 01-23-2001 01:11 PM |