Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-17-2002, 10:59 PM
|
#1 |
|
Registered Member
Join Date: Jan 2001
Location: Kintnersville, PA USA
Posts: 38
|
new motor is in and ready to tear except...
Just put the finishing touches on my new motor. It has TFS heads, TFS stage 1 cam w/ 1.7 rockers, TFS street intake, 24# hr injectors, 190 lph fuel pump. Everything was looking good and I tried to start here up. When i did it started to idle really rough at around 900 -1000 rpm and then it stalled. Each time i start it and try to let it idle it stalls. This is the first time i ever put a new motor in a car and am not sure where to go from here. I know that the distributor is put in correctly and all. When is revved up it stays running. I was wonderng if maybe i was running to much fuel pressure? it is set at around 40 psi. Would too much fuel make it stall at idle? Any suggestions or help would b greatly appreciated! Thanks for the help fellas.
__________________
91 LX: Green/white stripes, TFS heads, intake, cam, and 1.7 rockers. BBK longtubes, off-road h-pipe w/ flowmasters. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| new motor is in and ready to tear except... | StripedStangLX | Windsor Power | 4 | 04-19-2002 09:04 AM |
| My '82GT is almost ready!! | 82 GT | Windsor Power | 4 | 07-07-2001 10:26 PM |
| She is almost ready!!! | 88COBRA | Blue Oval Lounge | 2 | 04-23-2001 07:06 PM |
| Ready to Buy - What to Look For? | DEPete | Special Production | 2 | 03-27-2001 12:05 AM |
| Any tips before I tear her apart?????? | gray87GT | Windsor Power | 12 | 01-26-2001 11:22 PM |