Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-13-2002, 09:09 AM
|
#1 |
|
Registered Member
Join Date: Oct 2000
Location: Santa Lucia di Budoia, Italy
Posts: 217
|
Wiring ???'s for AOD to T-5 swap
Is there any way to wire it up so that I can start it? The car has 4 wires coming out and the harness on the tranny has 2 wires and one jumper wire. When I jump the wires coming from the car, the car starts while the key is on (rather than in the start position) and the starter stays on. I have to pull the jumper wire to stop the starter. I looked at the manual but it's not helping at all, it only shows 2 wires coming from the car. Can anyone tell me how to wire this thing up? Do I need to hook up the switches on the pedals? Other than this problem, the T-5 swap went well. I can't wait to drive this thing!! Just pulling it out of the garage was fun! Any help is greatly appreciated.
__________________
86 GT T-tops |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5.0 swap and wiring | surfsup | Windsor Power | 1 | 10-04-2004 11:24 AM |
| 351w swap oil pan (dipstick length ???'s) | fiveliter8 | Windsor Power | 2 | 06-07-2002 08:51 AM |
| Dash Wiring harness, and T-5 swap | Brady91 GT | Windsor Power | 4 | 10-31-2001 12:12 PM |
| wiring diagram ???'s | shelby2 | Classic Mustangs | 2 | 07-23-2000 07:32 PM |
| 2.3 turbo swap | frankiebonzz | Small Ponies | 0 | 06-01-2000 07:44 PM |