Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-19-2002, 06:46 PM
|
#1 |
|
Registered Member
Join Date: Sep 1998
Location: Berea Ky
Posts: 17
|
Car won't go straight with southside machine lift bars
I have a car that I built for a freind of mine and we took it to the track on 5-18-02 and with street tires on it the car went straight but when we put on slicks the car went straight until third gear. First and second gear it went straight but when you hit third gear the car's rear starts to the left hard and you have to get out of it to ever get it straight again. It goes so hard i almost hit the wall.
Has anyone had any experience like this and if so how did you correct this condition. Slicks were set at 12 psi and they were M/T ET drags. Any suggestions will be appreciated.
__________________
1986gt Vortech S-trim SQ,off road H-pipe,Edelbrock Intake, 1.7 rockers, 3.73gear,edelbrock 6039 cylinder heads and f303 cam. Best run so far 10.78@127.40 and 1.50 60 foot. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about SSM lift bars | skiwesser | Windsor Power | 17 | 05-05-2004 06:40 PM |
| South Side Machines Lift Bars..... | cucho | Windsor Power | 7 | 01-29-2004 10:51 PM |
| Answering machine greetings | Mustanguy | Blue Oval Lounge | 0 | 04-12-2003 01:38 AM |
| Lakewood Lift Bars | LaxMan | Windsor Power | 1 | 11-25-2002 09:25 AM |
| Lift bars for my 88 vert yes/no | Dark_5.0 | Windsor Power | 2 | 01-02-2002 07:43 PM |