Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-11-2002, 12:21 AM
|
#1 |
|
Registered Member
Join Date: Jun 2002
Location: colorado
Posts: 15
|
Fan Switch Wont Work???
Ok i've had the manual fan switch on the car for quite some time now and last night it wouldnt turn on, no problem I think, get it the garage today and redo the wire all pretty like, and it still wont work. When I flip my switch I can hear a clicking noise from under the hood but the fan wont turn on. The blade moves freely so I know the motor isnt shot and the computer still turns it on, just I cant, WTF. Can I hook up a wire to one of the three that go to the fan itself or no? Any help would be appreciated.
__________________
 **MODERATOR AT WWW.COLORADOSTANGS.COM** Cobra upper and lower intake, bbk 70mm throttle bodie, mac cold air kit, bbk/walbro 190lph fuel pump, pro m 75mm bullet mass air meter, jet computer chip, bbk lowering springs (1.5"), D&D adjustable upper rear controll arms, Indexed spark plugs, gripp caster/camber plates, under drive pullys, msd 6al ignition, msd blaster coil, taylor 10.5mm plug wires, bassani exhaust with an x, saleen ceramic headers, 3:73 gears, E-303 cam,1.6 roller rockers, aeromotive adjustable fuel pressure regulator, cobra r clutch, 180 thermostat, manual fan on/off switch (high), msd shift light, autometer volt, water and air/fuel carbon fiber, everything inside car, white faced guages, hurst pro 5.0 shifter, Pro-M Remote Optimizer And finally a new trans so now I can race again Next up, some suspension work. **Working on traction issue** 1/4 mile- 14.85@91mph at 5800ft above sea level 60'- 2.12 1/8 mile 9.52@72mph Just some fyi, my times would be about this at sea level: 1/4 mile- 13.6 60'-1.8 or 1.7 1/8 mile- 8.2 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| simple nitrous questions | 1jimmy__d | Power Adders | 29 | 07-14-2003 03:26 PM |
| Girl at work will not take NO for an answer! | Mercury | Blue Oval Lounge | 8 | 12-05-2001 11:43 AM |
| WIll stock gauges work when I switch to carb? | tireburner163 | Windsor Power | 3 | 11-26-2001 12:39 PM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |