Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
07-09-2002, 01:18 PM
|
#1 |
|
Registered Member
Join Date: Nov 2001
Location: Scappoose, OR
Posts: 42
|
Will it hurt the engine to run with the IAC unhooked for a few days?
I replaced the IAC over the weekend and my high idle is worse than before, except that every once in a while it will drop to normal levels. I unhook it and the idle is fine. I need to figure this out, but I won't have time to look at the EGR, TPS, codes until the weekend (unless someone has a quick, seat-o-the-pants answer) and I need to drive the car. I can't imagine it would do damage, but wanted to make sure. Thanx.
__________________
91 GT - White, MAC cold air induction (that's it so far) 69 GT - Winter Blue, 351, C-4, mild mods 69 Mach I - Acapulco Blue, 351, T-10, bone stock |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Need Help Did I hurt my 5.0 engine? | twilightcall | Windsor Power | 8 | 08-06-2003 10:04 PM |
| Rebuilt Engine Problems | sleeperstang | Classic Mustangs | 6 | 05-08-2003 10:19 AM |
| engine swap | Snakebite427 | Small Ponies | 2 | 10-19-2001 08:17 AM |
| check engine light after long tube install | tomazzzo | Windsor Power | 8 | 02-19-2001 05:49 PM |