Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-16-2002, 04:04 PM
|
#1 |
|
2 Stangs in the Stable
Join Date: Apr 2002
Location: Baytown, TX
Posts: 1,209
|
Misfire at low RPM
I have a problem with my car misfiring at a low RPM. from about 1500 to about 2500 it misses. Once you ecxeed the 2500 it lines out. I have a 302 crate engine bored out to a 306, MSD 6al, 70mm T.B., off road X pipe, pullies, mac equal shorties, cold air intake, and 3.73's. I thought it was the itming, so I took it to a local speed shop and when they adjusted the timging, it did nothing. After I left the shop, it got worse. I replaced the cap and rotor along with the plugs, and now I am back to where I was. Any suggestions would be greatly appreciated.
This started after I installed the MSD, x-pipe, and the throttle body. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GM Engines | BLOCKER | Blue Oval Lounge | 2 | 04-13-2004 12:35 AM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Edelbrock RPM Package | jim_howard_pdx | Classic Mustangs | 2 | 10-28-2002 04:57 PM |
| Experience with Edelbrock RPM Package | jim_howard_pdx | Windsor Power | 0 | 10-27-2002 01:10 AM |
| RPM difference between 3.73 to 4.10 | o2superstang | Modular Madness | 0 | 07-09-2002 06:58 PM |