Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-15-2002, 03:06 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Fuel Line
How many feet of fuel line do you think I will need to run from the rear bumper to the front fender?
Also, how do people get braided lines to attach to the heater core inlet and outlet? I saw a car with real braided line in a magazine, but I have never seen the fittings to do this.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fuel Line fitting | 289 | Windsor Power | 2 | 08-27-2004 01:50 PM |
| Return fuel line on 90 GT (UR .02 cents wanted) | BigCountryGT | Windsor Power | 2 | 03-15-2004 03:20 PM |
| Fuel Line Replacement | Tony Higley | Classic Mustangs | 3 | 12-18-2002 12:57 AM |
| fuel line Question | EazyE-CPT | Windsor Power | 5 | 08-08-2002 07:22 AM |
| fuel line problem | gray ghost86 | Windsor Power | 4 | 05-03-2002 11:43 PM |