Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-26-2002, 08:35 AM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
exhaust wrap
Has anyone had any expirence with header wrap? My headers are touching the starter and the clutch cable. I put heat shielding around the starter and cable, but they started to smoke after a few hours. I think I will have to wrap the entire headers since it is touching.
What is the best way to remove full length headers? from the top or the bottom. Thanks!
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra-R Side Exhaust -- SWEEET! | SkammyManX | Modular Madness | 3 | 04-05-2003 11:58 AM |
| Speed Secret # 4 | jim_howard_pdx | Windsor Power | 13 | 11-10-2002 03:42 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Header gaskets | Stang951 | Windsor Power | 18 | 11-01-2002 05:57 PM |
| Important Exhaust Question - Please Read | sublimelax | Small Ponies | 14 | 03-06-2001 10:14 PM |