Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-07-2002, 09:34 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: South Carolina
Posts: 58
|
Help! - Pedistal Rocker Question
My pedistal roller rockers seemed to go on as stated in the intructions. I had about 1/2 to 3/4 of a turn after the pushrod made contact to bolt tightening.
When I did the final torque I noticed that the valves seemed to be opening slightly during that last 3/4 of a turn. Is this normal. Do they bleed back? Have I #$%^&@ up???? Help. Tell me all is fine. Please.
__________________
Bobasaurus 1987 LX 5.0 - Engine Rebuild now installed - 26290 Wonderful Miles so far Items now installed from the garage : GT-40p heads, Explorer Intake, FMS "P" headers, Crower 15511, SFI Balancer, 24#, SPEC Stage 1, T5z, 65MM TB, 77MM Pro-M, 255lph Pump |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Roller rocker question? | HiFlow5 0 | Windsor Power | 1 | 05-18-2004 12:07 PM |
| Rocker Question. | Mopar1 | Windsor Power | 1 | 09-20-2002 09:02 PM |
| Rocker Arms Question | Falcons Talon | Windsor Power | 1 | 08-11-2002 11:27 PM |
| Roller rocker question | DemonLp | Windsor Power | 1 | 03-22-2001 04:19 AM |
| Rocker Panel Moldings Question | Matt683 | Classic Mustangs | 4 | 01-05-2001 02:46 PM |