Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-17-2002, 08:10 AM
|
#1 |
|
Registered Member
Join Date: Oct 1998
Location: Pitts. Pa. USA
Posts: 61
|
Timing
Ok, I read the great disertations as of 12/8 on timing. Really it was very helpful to me. Now, should I run my vacuum line from the distributor above the plates on into the base on my holley? It appears I should run it above to bring in the vac on a timed basis. Is there a situation where I would want to run it in the base?
Thanks,
__________________
87 LX, 74 351W, performer plus intake, holley 750, vac sec., 78 prim. 80 sec., 50 pump: Wolverine cam 292-512, windsor heads, ported 3 angle valve, 4:10 rear, AOD, Lentech valve body w/ 10'' converter. No time slips yet! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
| timing chain or timing gear | mustang66teen | Classic Mustangs | 11 | 06-18-2001 08:44 PM |
| nos & timing controller | todd5litre | Windsor Power | 5 | 01-09-2001 08:24 PM |