Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-15-2003, 08:27 AM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Hampton, Virginia
Posts: 227
|
Plasti-gauge strips
Ok, I have three different colors of these plasti-gauge strips and I don't see in the book where I would use them. I know they are for the crank but, does a 66' need them or do you just need to torque down to spec? Thanks. Hey Matt, took your advise and sent the car to the brake shop.
__________________
1980 RX7 with 289 Ford V-8 bored .030 over, Very radical cam, Torker 2 high rise intake, Holley 650 Carb, MSD Nascar 6ALN ignition, MSD coil and distributor, Headers with dual open side exhaust. Over 300 horse. 1966 Mustang still in progress |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attn: PKRWUD: Compression Test Results | 95mustanggt | Windsor Power | 13 | 06-22-2004 07:34 AM |
| fuel gauge install | GhettoPop | Windsor Power | 4 | 01-23-2004 01:41 PM |
| Boost Gauge Questions | SleeperGT | Power Adders | 3 | 10-01-2003 12:39 PM |
| Boost gauge, need help ASAP!! | Chris_H | Windsor Power | 6 | 05-24-2002 06:07 AM |
| The benefits of a Vacuum Gauge!!! | PKRWUD | Windsor Power | 16 | 07-02-2001 09:12 PM |