

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: May 2003
Posts: 86
|
![]() Hi, I was wondering if you can remove the smog pump and air injector rails etc., from the Mustang without harming it at all? I did see the Smog pump Eliminator. I noticed how tight it is in due to all of the smog gear in that area. I also noticed a lot of vacuum lines connected. Will removing these harm anything? Do I need to buy a new ex. manifold or are there plugs for the air injectors? My main goal is not HP gain but to make more room in my engine compartment with less clutter? I would probably need test pipes so I don't clog up the cats too. Thanks.
Last edited by twilightcall; 06-03-2003 at 05:25 AM.. |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adding A/C to a '66 Smog pumped V-8 | 65twa | Classic Mustangs | 7 | 09-22-2010 07:03 PM |
Safety Issue 64 - 70 Mustangs | Mach1 Cobra Jet | Classic Mustangs | 20 | 07-11-2005 08:06 PM |
Yellow Mustang Stampede TULSA OK August 17 | stylin99 | Ford Show & Go | 2 | 11-09-2004 11:19 PM |
smog specs 89 mustang lx | stanglx | Windsor Power | 4 | 09-11-2004 03:41 PM |
t-5, is it the same in the 4 cylinder and V8 | ex-lt1-guy | Windsor Power | 12 | 03-03-2002 01:59 AM |