Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-11-2003, 07:03 PM
|
#1 |
|
Registered Member
Join Date: Jul 2002
Location: Indiana
Posts: 51
|
Valvetrain Question
I have a 306 w/ AFR185's. I am running a .560" lift cam. I had my "machine work guy" check assembled height, valve clearance, pushrod lenght etc. He said it all was great! I have put about 200 miles on the new motor. The other day, I had some serious valvetrain chatter. I pulled the valve covers and found the intake pushrod almost out from underneath the roller rocker. The perma-loc was finger loose. I am guessing that I missed one when tightening them up?
My question is this, I am running a stock length pushrod (6.25"). Do you think that this sounds right? AFR, along with most other aftermarket head companies, recommends a little longer pushrod. I would like some input on what you might recommend. Thanks Brent |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another tire question | 96Saleen | Modular Madness | 6 | 02-10-2004 05:27 PM |
| A stupid question I hate asking about exhaust sound | jwboner | Windsor Power | 4 | 08-05-2003 05:55 PM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| Valvetrain question for Edelbrock 6037's | Blaster | Windsor Power | 1 | 05-25-2001 01:26 PM |
| Newby here, I have a question on Odometers | mustangmama | Blue Oval Lounge | 3 | 03-03-2001 06:43 AM |