Quick Questions...Some dumb ones.

Mercury · 01-30-2004, 02:59 AM

Got the magic 1000 mile mark on the new motor, so tonight I set out to seriously figure it out. After alerting every cop within miles by my blasting down the All American Highway I decided to move to other proving grounds.

So, out in the country I went and used a few back roads. After marking off a quarter mile, I perceeded to figure out how to get the most out of my suspension. Cant use first for much else other than to get the car rolling and set for second gear RPM. Second gear I can now Mat to the floor and half the time it does good, the other half it just spins.

Through my plethra of runs, I noticed the car acts real inconsistant. When getting the chip burned, the man mentioned that my Mass Air meter could cause such problems as I am encountering. I'm thinking of going to a Lighting Mass Air Meter if that does turn out to be the prob.

The best I got out with 40 percent throttle on first, matting second, shifting at 6600 RPM was 113 MPH. Thats an AVERAGE of five runs down with those shift points. I was only going to do 3, but I wanted to make sure I got the MPH right. Yes, the speedo is correct.

Question #1. What kind of ET would one expect with that Trap Speed??

Question #2. Has anyone heard of a Mass Air Meter causing consistancy problems??

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Quick questions on Explorer Intake install.	Falcons Talon	Windsor Power	2	08-21-2003 12:40 PM
Couple of quick, stupid questions!	SCOTTLT79	Windsor Power	4	02-15-2003 04:02 PM
Quick Help Questions - Need to pass inspection on the 66 Stang!	bigbandjohn	Classic Mustangs	10	01-26-2003 10:14 PM
Two quick questions	302 LX Eric	Windsor Power	3	09-07-2001 06:25 PM
Last minute engine dressup and other quick questions before car show... PLEASE HELP!!	WA2FAST	Windsor Power	1	08-09-2001 12:44 PM

01-30-2004, 02:59 AM	#1
Mercury The Redneck James Bond Join Date: Sep 2000 Location: Fayetteville NC Posts: 1,707	Quick Questions...Some dumb ones. Got the magic 1000 mile mark on the new motor, so tonight I set out to seriously figure it out. After alerting every cop within miles by my blasting down the All American Highway I decided to move to other proving grounds. So, out in the country I went and used a few back roads. After marking off a quarter mile, I perceeded to figure out how to get the most out of my suspension. Cant use first for much else other than to get the car rolling and set for second gear RPM. Second gear I can now Mat to the floor and half the time it does good, the other half it just spins. Through my plethra of runs, I noticed the car acts real inconsistant. When getting the chip burned, the man mentioned that my Mass Air meter could cause such problems as I am encountering. I'm thinking of going to a Lighting Mass Air Meter if that does turn out to be the prob. The best I got out with 40 percent throttle on first, matting second, shifting at 6600 RPM was 113 MPH. Thats an AVERAGE of five runs down with those shift points. I was only going to do 3, but I wanted to make sure I got the MPH right. Yes, the speedo is correct. Question #1. What kind of ET would one expect with that Trap Speed?? Question #2. Has anyone heard of a Mass Air Meter causing consistancy problems?? __________________ 64 1/2 "D" code Red Mustang Coupe. Red Baron, 2000 Perf Red Mustang GT. 5spd. Stage 2 CNC heads with Large Valves, Comp Cams (270-274 dur .550 lift), Forged Crank, DRP pistons, Manly H-beams, Pro M 87 mm Mass Air, 24lb Inj, 75mm TB, Plenum Spacer ,Long Tube Headers, Homemade H-pipe, 2 chamber Flows, 4:10's, Steeda Tri-Ax, LKW 70/30's, Eibach Drag Springs, Steeda SubFrames, Battle Boxes, Rear Girdle, Adj uppers, Alunimum Drshft, Southside Lift Bars. Project Cars, 64 1/2 6cyl coupe, 1930 Model A Nostalgia Rod.