Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-28-2004, 04:22 AM
|
#1 |
|
Ride Hard
Join Date: Oct 2000
Location: Wyoming IL
Posts: 1,094
|
valve floating with e7te's
can the stock e7's run higher rpm's without pulling out one of the rocker mounts? I think I am going to run the stock cam in a 92 block for now, but I am not sure if I need to update the springs from stock and/or have the heads machined for sutd roller rockers.
the only reason this is an issue, is because this motor needs to still pull good aroun 6-7000 rpm range. The 4.10 gears have it revving hard across the quarter. Any help you guys can give is greatly appreciated. I have been told the stock cam will be fine with the 92 ho motor...ported e7te's, but am unsure about the valvetrain. Ryan
__________________
65 Fastback 91 roller 306, H/C/I AOD-Bauman, PI Stallion, 4.10's and traction loc 04 Grand Cherokee Freedom Edition 79 Ford F-250 4x4 - Restored |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Need Valve Springs for E7TE's | shadowblue89 | Windsor Power | 2 | 01-23-2002 03:41 PM |
| Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
| Valve Springs & Roller Rockers | StreetStang37 | Windsor Power | 4 | 04-17-2001 03:54 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |