Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-06-2001, 12:15 AM
|
#1 |
|
Registered Member
Join Date: Jun 2001
Location: Lincoln, Nebraska USA
Posts: 67
|
Vacuum
After I was done replacing my EGR valve, i thought i would check to see what kind of vacuum it needs. i started the car and let it idle. I put my finger over the Vacuum line and didn't feel much. I gave it a little throttle and could feel a little pull on my finger. I then pulled the line off the Fuel Pressure Regulator and put my finger over it. At idle it had enough to keep my finger stuck on it. Had lots more pull than the EGR vacuum. Should it be this way, or is there a vacuum problem somewhere?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W crankcase evacuation | jse9 | Windsor Power | 19 | 09-03-2004 12:00 AM |
| Performer RPM | -RootS- | Windsor Power | 4 | 04-25-2003 06:24 PM |
| Still Misfiring | MidNiteBlu 5.0 | Windsor Power | 17 | 12-02-2002 09:43 PM |
| Need vacuum advise before I start the engine tomarrow-please help | Stang_ROTY | Windsor Power | 12 | 07-23-2001 12:41 PM |
| The benefits of a Vacuum Gauge!!! | PKRWUD | Windsor Power | 16 | 07-02-2001 09:12 PM |