Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-01-2004, 08:41 AM
|
#1 |
|
Registered Member
Join Date: Mar 2004
Location: Long Island
Posts: 58
|
RPM performer heads w/2.02 intake valves ?
How much power would the RPM performer heads w/2.02 intake valves, heads give me (guestimate), if im running gt-40 upper and lower, on a 10.5.1 motor, over my old gt-40 alum. heads ???
i found a pair for $800 bucks brand new with 1.7 svo rockers
__________________
1990 Mustang GT Engine- 308 (bored .40 over) Probe Forged pistons (10.5:1), Scat forged crank and rods, w/Main Girdle, AFR 185 heads, GT-40 intake, CSI electric water pump. AC delete kit, No smog pump, Manual rack and pinion steering. Ignition- MSD 6AL, MSD Blaster coil, MSD hellicore wires. Drive Train- Tremic 3550, Alum. Drive shaft, 3:73 gears, Stock carrier and axels. 26X11.5 M/T Et streets. Power adder- 175 shot of laughing gas. Best ET 11.5 @120mph on squeeze, 12.4 @109mph on muscle (on gt40 heads) on the 185 heads ... ??? tba Last edited by leathal injection; 06-01-2004 at 03:22 PM.. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NOS ? with performer RPM Intake?? | vande97 | Windsor Power | 3 | 03-22-2002 10:02 AM |
| Heads, intake.......AND BEYOND! | dinomite | Windsor Power | 6 | 03-29-2001 04:24 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |
| Cobra or Trick Flow intake with GT40P heads? | Shotgun28 | Windsor Power | 16 | 01-24-2001 04:15 PM |
| Performer RPM vs. Track Heat which is better for my setup? | MY91GT | Windsor Power | 0 | 01-19-2001 12:52 PM |