Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-25-2001, 04:22 AM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: altoona pa usa
Posts: 49
|
Old block new bearings
Are you able to put new bearings and rings in without getting anything prepped or checked? This is assuming that the bores are still within the tolerances.
------------------ 90 GT 150k on the motor never had the valve covers off, 1 5/8" headers, x-pipe, 2chamber flowmaster,fms aluminum ds, 3.55, best time on 245/45/17 2.08 60', 13.906 @ 98.98 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rebuild HiPo 289 using M-6010-B50 Sportsman block | skidado | Classic Mustangs | 3 | 10-18-2003 01:52 PM |
| rebuild vs stroker short block | Dave_mustang_50 | Windsor Power | 6 | 01-08-2003 02:07 PM |
| Need help deciding on an engine block!! | 93 Cobra needs input | Windsor Power | 6 | 10-23-2002 05:29 PM |
| What makes a Small block a Small block and a Big Block a big block? | gtsr515 | Windsor Power | 13 | 05-20-2002 10:25 PM |
| Big block or small block? | MuscleCarFanatic | Classic Mustangs | 2 | 07-12-2001 03:27 PM |