AC & ignition questions

yusuf · 03-28-2000, 06:21 PM

Hi guys. I have a 65 with a 351W going into it shortly. What are my options for putting in an AC, and what do you recommend? I hear R134 is easier/cheaper in the long run.

Also, what distributor/ignition should I put in it?

Thanks for any info or recommendations you may have.

Ron1 · 03-28-2000, 08:29 PM

Not sure on the AC, but for the ignition use the MSD 6AL and either a Jacobs Ultracoil or a Blaster II. I use Taylor wires since they are HIGHLY recommended by my engine builder. You might also consider the MSD distributor.

Ron

[This message has been edited by Ron1 (edited 03-28-2000).]

03-28-2000, 06:21 PM	#1
yusuf Registered Member Join Date: Jul 1999 Location: San Francisco, CA Posts: 56	AC & ignition questions Hi guys. I have a 65 with a 351W going into it shortly. What are my options for putting in an AC, and what do you recommend? I hear R134 is easier/cheaper in the long run. Also, what distributor/ignition should I put in it? Thanks for any info or recommendations you may have.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Questions on Roll Cages, Welding, and Ignition	BlackFireN2O	Windsor Power	3	08-25-2002 08:01 AM
Ignition Problems with '87 5.0. HELP!!!	Holly	Windsor Power	12	03-17-2002 05:53 PM
Ignition frabrication...needs some ideas	1989_351W	Windsor Power	0	08-11-2001 04:52 PM
Ignition switch questions - Please help	2FastLX	Windsor Power	6	07-20-2001 03:41 AM
Ignition upgrade questions	Chevyguy	Windsor Power	4	03-26-2001 02:14 PM

03-28-2000, 08:29 PM	#2
Ron1 Registered Member Join Date: Sep 1999 Location: Vancouver, WA USA Posts: 439	Not sure on the AC, but for the ignition use the MSD 6AL and either a Jacobs Ultracoil or a Blaster II. I use Taylor wires since they are HIGHLY recommended by my engine builder. You might also consider the MSD distributor. Ron [This message has been edited by Ron1 (edited 03-28-2000).]