Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-15-2002, 12:24 PM
|
#3 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
I once had a leak in the gaskets between the throttle body/egr/intake and my intake filled up with this putty like substance. All of my collant got sucked into the engine. it was not a fun clean up. Take the intake tube off of the TB and see if there is a leak before it gets worse.
It could also be the lower intake gaskets. Did you purchase intake gaskets with silicone around the water passages? If not, did you put a small bead around them before you lowered the intake in place?
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A little coolant leaking...??? | 1hot5.0 | Windsor Power | 2 | 07-24-2002 01:09 PM |
| new engine= yay, coolant in the oil= *****! | fiveohpatrol | Windsor Power | 14 | 07-22-2002 04:38 PM |
| coolant q's? Am I a complete idiot? | Rally | Modular Madness | 3 | 03-04-2002 07:07 AM |
| Coolant Low...Coolant Odor....D@MN! | abesmith69 | Windsor Power | 6 | 12-27-2001 10:28 AM |
| Low Coolant Light | RMARIANI | Windsor Power | 5 | 06-10-2001 10:00 PM |