Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-01-2002, 04:09 PM
|
#8 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
Put the pump on without the shaft, and put the shaft in from above (thru the distributor).
Pull the distributor: Mark where the rotor starts on the base-cap (bottom 1/2 of the plastic distributor cap). As you pull up and out, the gears will rotate the rotor... Mark the base-cap where the rotor stops, as you eeeease out the dristributor straight up. THat way when you install, you can align it in reverse, begin at the end, and slip the distributor down, and it shoudl fall into place at the start mark was.
__________________
Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Removing Fuel Rails?? NEED HELP ASAP | 5.0 Pony | Windsor Power | 4 | 06-12-2003 02:24 AM |
| Removing A/C | bobtodd | Windsor Power | 8 | 04-27-2002 09:57 PM |
| installing a cam without removing engine | vetteeatr | Windsor Power | 7 | 01-24-2002 01:38 AM |
| Installing Electric Fan and Removing AC | SmokeyDP | Windsor Power | 3 | 03-09-2001 07:10 PM |
| can i inst. rocker arms without removing lifters? | rob90gt | Windsor Power | 3 | 02-02-2001 04:09 AM |