Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-09-2001, 03:31 PM
|
#4 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
is your car still speed density? if it is it will probably give you some problems, yes some people go pretty big on cams with SD but it doesnt work for every setup, i've heard a B303 is a cam that wont give SD problems, try it and see, you may be ok
------------------ 88 Notchback 5.0, 3.73's, Explorer intake, pulleys, Crane 1.7's, BBK headers, off-road H-pipe, flowmasters, subframe connectors, 65mm TB, shift kit, March ram air kit, motorsport wires, MSD coil, upper and lower control arms, 155lph fuel pump, cheap 2800 stall, Crane Adj.FPR, best time- 13.99@99.75, not yet tested times after rocker and intake install |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is this a good deal? | 82 GT | Windsor Power | 6 | 10-08-2002 07:13 PM |
| Is this a good deal? | stevstum | Windsor Power | 7 | 09-25-2002 02:46 PM |
| Is this a good deal for motor and tranny? | Chris_H | Windsor Power | 5 | 08-25-2001 01:10 PM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |
| Brembo = Good! (installation tips included) - long | 97snakedriver | Modular Madness | 1 | 09-18-2000 09:05 PM |