Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-24-2001, 07:05 PM
|
#4 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
I went with the edlebrock's for my 392 stroker buildup. I've heard that I might have made a bad mistake due to the large cubes v. relatively low flow #'s. The heads are very nice though, and my engine builder is very satisfied. tThe motor is going together in about 2 weeks so I'll let you know.
------------------ In progress for Spring: 93 GT less motor and tranny, 8 pt cage, chute, Sothside Machine bars & Sub-frames, 3.73's '69 393 stroker Edlebrock Performer heads, Performer RPM Upper & Lower Manifold..Crane Gold 1.6 Rollers..BBK 70MM TB & cats..30lb Injectors..Cartech Fuel System.. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock Performer 5.0 Heads | white91gt | Windsor Power | 1 | 08-03-2004 12:18 PM |
| Edelbrock 5.0 or Trick Flow Street? | Bad89stang | Windsor Power | 6 | 11-19-2002 12:00 PM |
| Torque specs for trick flow heads? | Coupe5oh | Windsor Power | 1 | 03-16-2002 09:25 AM |
| Trick Flow heads??? | AB89GT | Windsor Power | 10 | 09-06-2001 05:57 PM |
| Trick Flow Cams? | 86GT | Windsor Power | 5 | 01-11-2001 08:31 PM |