Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-20-2003, 05:17 PM
|
#2 |
|
dude5l
Join Date: May 2001
Location: Grande Prairie, Alberta, Canada
Posts: 603
|
Was it an eight cylinder car before? If not then a bigger rear end, (8.8 or 9 inch), front springs, and brakes to start, then a different drive shaft, motor mounts, shifter, hood may not fit anymore, possibly the brake booster, (although the 86 & up boosters I think will fit, I just went to a manual setup). Thats just a start, I'm sure you will get lots of replies of thing I have forgotten about. Is it worth it? To a point it is, you can't beat the torque of a big block, but it can be a lot of work.
__________________
Good luck! Brad R. 1992 L.X. 5.0 coupe MODS: A few little bolt ons  New Best time ...11.60 @ 128 mph @ 2000+ ft altitude. Rice Haters Club member #39 Users rides #2542 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Thinking of 99 head swap? BEWARE... | 97ScottieGT | Modular Madness | 7 | 03-14-2002 01:43 PM |
| Need major advice please!! Am I thinking correctly? | Nic92LXConv50 | Windsor Power | 9 | 06-23-2001 10:51 PM |
| Considering the swap to a 351W - need advice | 2FastLX | Windsor Power | 22 | 06-11-2001 06:46 PM |
| 351 Swap Experts.... I Need some advice please | Stang_ROTY | Windsor Power | 2 | 04-06-2001 12:45 AM |
| Advice on Axle swap | Steve Peterson | Classic Mustangs | 2 | 09-04-1999 09:38 PM |