Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-26-2004, 12:59 PM
|
#8 |
|
Moderator
Join Date: Aug 2000
Location: Milan, OH
Posts: 2,699
|
The ride height depends on the weight distribution so your results might be different than the other guy's. I put the 4-cyls on all four corners of my car and ended up cutting 2-3/4 coils out of the front and 2 coils out of the rears to get the height where I wanted it. My car basically sets in the weeds, for weight transfer purposes. My 26x4.5 E/T Fronts were basically tucked up into the wheel well with this much taken off the fronts. My car sits low enough that I can't slide my 3-ton floor jack under either end without lifting up on the car.
__________________
Jeff Chambers 1990 Mustang GT 10.032 Seconds / 137.5 MPH 14-time Street Warrior World Record Setter CRT Performance 2001 Tropic Green Mustang GT - 12.181 / 113.2 MPH 2002 Ford F-250 Crew Cab 7.3l Power Stroke - 17.41@77.2 "There's nothing boring about a small block automatic shifting gears at 9400 rpm!" |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front End Wobble | orlowted | Classic Mustangs | 6 | 04-14-2004 02:23 PM |
| front springs | greydan | Windsor Power | 3 | 06-27-2002 11:23 PM |
| Bent springs??? | 5.0PiMpin | Windsor Power | 2 | 05-26-2002 10:20 PM |
| Front End: Repair or Replace | ttremblay | Blue Oval Lounge | 3 | 01-31-2001 10:18 PM |
| Need new front tires... suggestions... | FivepointOH | Windsor Power | 4 | 01-01-2001 11:20 PM |