Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-13-2001, 03:12 PM
|
#1 |
|
Sober voice of Reason
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
|
Just out of curiousity slowride90, what are you using for a throttle cable bracket? I was looking at a performer RPM manifold and I noticed the bolt holes for the throttle bracket go parallel to the throttle linkage rather than on an angle, mine wouldn't fit.
------------------ GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B+M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carb swap info | RoushRacing6N17 | Windsor Power | 2 | 02-13-2004 01:07 PM |
| EFI to Carb swap on a 88 | RoushRacing6N17 | Windsor Power | 7 | 12-08-2003 07:43 PM |
| Carb swap, Yeah or nay? | bigred90gt | Windsor Power | 4 | 11-01-2002 09:56 PM |
| EFI To Carb Swap | 86GT | Windsor Power | 2 | 08-06-2002 07:33 PM |
| elictrical considerations for EFI to Carb swap | redrider | Windsor Power | 1 | 05-01-2001 08:46 PM |