Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-24-2001, 02:46 PM
|
#8 |
|
Registered Member
Join Date: Aug 2000
Location: santa ana ca
Posts: 1,349
|
Hey 88GT, I think I might have that mismatch problem you were talkin about. That was the only size summit offered so I bought it. If I port match the exh ports will that make up for the difference? The tubing looks fatter than the flange that meets the head. The flange is about the same size as my head ports already but the tubing looks larger. Would the fact that I have a decent cam make up for the larger tubing since it will be making more exhaust than stock? Please let me know.
------------------ 95GT B303 cam, 1.7 rockers, 65mm TB, 73mm MAF, milled heads, 355's K&N, off road pipes, pulleys, msd coil, 9mm wires, Tremec 3550, Pro5.0 shifter,10.5 Motorsport clutch, weld in subframe connectors |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| loss of power suddenly | jimdrechsler | Windsor Power | 17 | 09-30-2004 08:49 PM |
| Power for the Power Amp | traderguy | Audio, Security, & Electronics | 2 | 07-13-2003 08:07 PM |
| Lost top end power | bobtodd | Windsor Power | 11 | 08-01-2002 10:28 PM |
| power shift? | JamGtStang | Windsor Power | 6 | 03-01-2001 02:11 PM |
| Electrical power, where to splice? | Chris_H | Windsor Power | 3 | 02-11-2001 08:29 PM |