Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-13-2001, 10:36 PM
|
#1 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
As long as you keep the fuel pressure down, the 30lb'ers wont be to big. Its MUCH better to be running a little rich compared to pulling your hair out worrying if its gonna blow up because its too lean.
I think a good set of 28 spline axle's would suit you fine unless you plan on running slicks alot then it would be iffy. This way all you'd have to do is slip the axles in and wouldnt have to change out the diff.
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
| Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
| Header advice | mustangLX92 | Windsor Power | 8 | 11-09-2001 02:43 AM |
| Building a 351w, advice | dinomite | Windsor Power | 1 | 02-06-2001 03:20 AM |