Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-27-2001, 09:15 AM
|
#4 |
|
Guest
Posts: n/a
|
Yeah check to see if the driveshaft is turning, and if so I would check the rearend. If not plan on a bad input or output shaft. Check your torque converter nuts to make sure they are still on and tight. I have heard of them shearing, and vibrating off.
Hope this helps. Jason [This message has been edited by 88GT5.013.02 (edited 03-27-2001).] |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Automatic ECU vs. Stick ECU | Mike Mileski | Windsor Power | 2 | 01-03-2002 02:36 PM |
| Need advice on changing automatic to 4 speed | blagintony | Classic Mustangs | 0 | 12-30-2001 10:29 PM |
| WARNING ABOUT PERFORMANCE AUTOMATIC | 84GT+NOS | Modular Madness | 1 | 09-15-2000 09:04 AM |
| WARNING ABOUT PERFORMANCE AUTOMATIC | 84GT+NOS | Classic Mustangs | 0 | 09-14-2000 05:38 PM |