Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-12-2002, 09:15 PM
|
#3 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
I am not a cam expert but I would think that would be a little too much cam for your combination. I do not know how much clearance those pistons will allow but I would think it would clear but you might have problems and the only way to be sure is to check clearance when installing it.
I think the x cam would be a better choice but an even better idea would be to call comp cams cam hotline and ask what they recommend. Almost any cam with a split pattern should be a good nitrous cam.
__________________
James Cox RHC Member #44 nochevy@hotmail.com 1991 Mustang LX Dart iron eagle block, 4340 28oz 347 crank, 4340 h-beam rods, probe ultra light pistons canfield heads “race ported by Brent Frazier”, solid roller cam and lifters “custom grind”, kooks 1 7/8" race headers, and much more. Engine built by Brent Frazier. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Car running lean, any suggestions? | MATTKNIGHT | Windsor Power | 10 | 03-08-2009 03:52 PM |
| My friend is Running WAY lean | TMASTER | Windsor Power | 5 | 07-13-2003 09:41 PM |
| What headunit are you running? | tireburner163 | Audio, Security, & Electronics | 0 | 04-22-2003 01:33 AM |
| Fuel pump will not stop running | MustangGT1990 | Windsor Power | 7 | 01-29-2003 10:41 PM |
| Car's running hot... | Sonics2042 | Windsor Power | 8 | 07-16-2002 04:50 PM |