Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-18-2002, 12:33 AM
|
#12 |
|
Registered Member
Join Date: Oct 2001
Location: Mannheim, Germany
Posts: 124
|
I got the Steeda 3 point, and it made quite a difference in cornering. I don't have sub-frames (yet), so I'm running stock setup for handling. Install was only slightly annoying, not too bad. Removing completely would take me maybe 30 minutes MAX, and the same to re-install. Original install took longer due to drilling. Some hard-core will chop off their nads to save a pound. Not me. The brace weighs 5 pounds. Stop drinking a case of beer a night, that'll make up for it. As far as the brace goes, I love it, now I just need more traction for gunning it out of the fast turns.....
__________________
89 LX 5.0 Notchback, FINALLY NO LONGER STOCK! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strut Tower Brace | saleen243 | Windsor Power | 1 | 02-18-2003 04:52 PM |
| Help! Strut Tower Brace - Will it fit w/this intake? | daveGT | Windsor Power | 5 | 08-05-2002 04:24 PM |
| caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |
| strut tower brace | BLK99GT | Modular Madness | 4 | 05-12-2000 06:14 PM |
| Strut tower brace install? | Ripper | Modular Madness | 1 | 03-28-2000 10:47 AM |