Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-22-2000, 09:23 PM
|
#5 |
|
Guest
Posts: n/a
|
Sorry I meant if you are taking your whole engine out, if you decide to change the oil pan gasket. I know it is just as easy to put heads, cam, and intake in the car. But if you you were to do it with the engine out, putting on all new gaskets is cheap insurance to avoid a leaks.
------------------ 88GT stock shortblock, ported GT-40 iron heads, ported Edlebrock Performer intake, 24# inj, Pro-M 75mm Bullet MAM, 3.73, hurst short throw, F-303, electric fan, alum rad, FMS HD clutch, R134a ac conversion, 70mm TB , and some other stuff I probably forgot, best run so far on ET streets is 13.02@106 with a 1.87 60ft. |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| head gaskets...GOOD ones | 88workcar | Windsor Power | 9 | 03-26-2003 06:06 AM |
| Intake and head advice | taurus3298 | Windsor Power | 3 | 05-09-2001 06:55 PM |
| Head ID and Extrude-honed Upper intake | RSE1805 | Windsor Power | 1 | 03-23-2001 05:03 PM |
| Gaskets - Which ones and where do I get them from? Please help quick. | 2FastLX | Windsor Power | 1 | 03-14-2001 12:08 PM |
| Where to get TFS intake gaskets? | gt93mustang | Windsor Power | 1 | 02-04-2001 05:09 PM |