Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-04-2001, 10:30 PM
|
#2 |
|
Sniffed too much n20
Join Date: Oct 1998
Location: Ont, Canada
Posts: 1,018
|
If you can, get the tool that you can flycut your pistons with. Check your clearance tho, some heads and cams do fit, but make sure. Otherwise, and not really recommended but will do the job, get a good bit for a Dremel and cut the valve reliefs for the pistons out.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Who carries ferrera valves? Is a stratched valveface salvagable? | crazypete | Windsor Power | 3 | 07-30-2004 08:26 PM |
| 2.02 valves GT40X Heads ? | T5superduty | Windsor Power | 0 | 10-24-2003 02:11 AM |
| adjusting valves/ stud mount?? PKRWUD? Anyone?? | Simi Stang | Windsor Power | 8 | 07-08-2003 11:43 AM |
| Pistons for Larger Valves? | MustangChile | Classic Mustangs | 4 | 02-28-2003 01:27 AM |
| Who's flycut stock pistons for 2.02 intake valves? | jmx2 | Windsor Power | 9 | 09-05-2001 07:59 AM |