Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-12-2002, 07:33 PM
|
#4 |
|
Registered Member
Join Date: Jul 2001
Location: West Bloomfield, MI
Posts: 391
|
if it has a groove cut into the heads (which it seems like it does) its for a loc-wire. as long as it does not have an actual ring that sticks out of the head then it is for sure set up for a loc-wire. good pictures and post by the way!
hope it helps, adam
__________________
90 GT black/ grey leather ported GT-40 heads w/ 1.7RR, Cobra intake w/ ported lower, 24# injectors, 190LPH pump, 75mm Pro-M MAF, 65mm TB, K&N panel, BBK long tubes, Off road H-pipe, 2 ch. Flowmaster, Black magic fan, Kirban FPR, 180 deg. T-stat, 3.73's, Steeda Tri-Ax, 130 amp alt. Accell 8.8 race wires/cap/rotor, motorcraft plugs, Factory Five suspension, etc etc etc.... http://avbcon12.stangnet.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HEGO orange wire grounds to manifold?? | Simi Stang | Windsor Power | 2 | 12-19-2003 08:13 AM |
| again, How to cure code 66 (maf below minimum voltage) ???? | HAITHAM | Windsor Power | 6 | 11-12-2001 09:10 AM |
| stator wire..where does it go? | 82 GT | Windsor Power | 9 | 07-04-2001 10:40 PM |
| Help me find an underhood ignition wire | 8850 | Windsor Power | 1 | 06-09-2001 05:11 PM |
| Aftermarket gauges in 85 dash, wire breakdown inside | RUSTANG | Windsor Power | 2 | 02-12-2001 11:06 AM |