Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-13-2002, 12:47 AM
|
#6 |
|
Registered Member
Join Date: Jan 2001
Location: Salt Lake City
Posts: 117
|
The groove for lockwire gaskets must be .010" deep and the tolerance is +/-.001.
I recently called felpro because I had an issue with the depth of my grooves and they faxed me the spec sheet for the machining. You can call them or I could fax it to you tomarrow. It's at work. BTW don't know if you have TFS heads but their instruction sheet has the same info about the .010 depth. Dan
__________________
Spec Service (UHP), BFG G-Force KDW's, Turbo Coupe 3.55 rear w/disks, 73mm calipers, Stg 1 Twisted Wedges, TFS Street Intake, 70mm TB, E cam, Crane 1.7's, Aeromotive FPR, BBK 1 5/8 shorties, elec fan, FMS Al Radiator, Moroso Wires, Kenne Bell Ramair, March pulleys, Race Magnums, 190 lph Walbro, FMS Al Dshaft, D/S loop, MM 4point rollbar, FMS C spngs, strut tower brace, Tokico Illuminas, Prothane bushings, MM Lwr Conrol Arms, KB welded subs, Cervini Mach 1 hood/valence/side skirts/wing/airdam. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HEGO orange wire grounds to manifold?? | Simi Stang | Windsor Power | 2 | 12-19-2003 08:13 AM |
| again, How to cure code 66 (maf below minimum voltage) ???? | HAITHAM | Windsor Power | 6 | 11-12-2001 09:10 AM |
| stator wire..where does it go? | 82 GT | Windsor Power | 9 | 07-04-2001 10:40 PM |
| Help me find an underhood ignition wire | 8850 | Windsor Power | 1 | 06-09-2001 05:11 PM |
| Aftermarket gauges in 85 dash, wire breakdown inside | RUSTANG | Windsor Power | 2 | 02-12-2001 11:06 AM |