Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-22-2002, 08:39 PM
|
#1 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
I got the BFG's and don't believe their sizes. Add about a half of an inch to the width. I ordered the 10 in. street slicks from Summit and they are 10.5 mounted. I have the lip removed on the rear fenders and they still rub going around corners. I made a change to the shocks going from Lakewood Drag shocks to some Koni's and the rubbing decreased a little. Just a warning. I'd take 1BAD89's advice if I were you. Good luck.
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| questions about my new 65 mustang | bmxmon | Classic Mustangs | 2 | 03-31-2004 07:13 PM |
| Quick questions on Explorer Intake install. | Falcons Talon | Windsor Power | 2 | 08-21-2003 12:40 PM |
| New Gears, Install, and Questions | B2r3y | Windsor Power | 6 | 02-21-2003 05:00 PM |
| Have questions about your blower? J.R. Granatelli attending chat tonight! | 88COBRA | Windsor Power | 0 | 02-12-2003 11:59 AM |
| HELP! Newbie 95-96 GT questions | Ron Brooks | Modular Madness | 1 | 07-09-2001 01:40 PM |